You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
This may be a "corner case" but I have written a spindle warm up that does not move any of the axis. I expected the code to run, and watch the RPMs to go up and down with time.... but I get nothing.
Code snippet:
(Safe block)
(G20 Units: inches)
(G90 Absolute distance mode)
(G17 work on in the X & Y plane)
(G80 cancel all active canned cycles)
(G40 turn off cutter compensation)
(G49 turn off tool length compensation)
G20 G90 G17 G80 G40 G49
(Work offset: G54)
G54
(4500 RPM, turn on spindle CW)
S4500 M03
(Dwell 60 seconds)
G04 X60
(Stop spindle)
M05
(end the program)
M30
Activity
jcoffland commentedon Jan 9, 2024
CAMotics does not currently simulate dwells. Also, the correct code for a dwell is
G04 P60.[-]Spindle warm up GCode ... yup no axis move[/-][+]Simulate dwells (G4 P-)[/+]ShamanTcler commentedon Jan 9, 2024
Oh how I wish there was an ANSI standard for GCode. Seem some dialects of GCode support something like
as far as you are concerned, do you support:
or must it be:
jcoffland commentedon Jan 9, 2024
Only the middle one.
The GCode supported by CAMotics is described here: https://camotics.org/gcode.html There is a GCode standard, RS274/NGC. Not everyone follows it.